End of Material Sensor (Electro-mechanical) Sensors Residual voltage 1 V max

Residual voltage 1 V max

120 g Case PBT (polybutylene terephthalate) Lens Modified polyarylate

When used with Wintriss die protection controllers

Control output Load power supply voltage: 26

End of Material Sensor (Electro-mechanical) Sensors Residual voltage 1 V maxThe End of Material sensor is designed for metal stamping applications. It detects material run out, and prevents pulling of the coil end through the feeder or straightener. It also keeps the press from running without coil stock. The sensor is typically installed so that the arm rides on the material. When the material runs out, the arm drops onto the insulated pin below it, generating a ground signal that is detected by the die protection